Anybody know how to log in to HIMSA to download Unitron Truefit 4.3.1?
Don’t think that’s possible, you don’t need HIMSA/NOAH to download manufacturers software, don’t go there,check your PM.
3 Likes
Hi! I need Truefit, too. And I didn’t want to open a new topic. If it is possible, could you share “how can I download /access truefit?” with me?
1 Like
Hi, I am currently testing a Unitron HA, I have Noalink and done some other fittings.
Is someone able to provide me Truefit software?
Kind regards!
Hello Again. There hearing aids arrive, with a bit of a cluster… It turns out Relate (the Unitron made brands new 2021 house brand for United Health Care Hearing), while virtually identical to comparable Unitron aids, has its own software.
Fortunately it is downloadable, it works with my Hi Pro, and after buy a set of connector cables I am able t to fine tune them.
Unfortunately, the audiologist determined that the custom molds are a little bit small, not as tight in my ear as he’d like to see, and is causing a bit of squealing occasionally.
Fortunately, they are in the trial period and he is sending them back to have new shells made.
They have 14 EQ bands, vs 12 on my past couple of brands. The potential is there for much better music playing/singing adjustment and have already made great headway.
The insurance co-pay was $575 each, so for under $1200 for the pair I am getting some pretty darn nice CIC hearing aids.
Can you also send me information on how to download the Unitron Truefit manufacturer’s software?
1 Like
Ich brauche auch Truefit 4 da ich einen Icube I habe.
1 Like
Hello, I am also looking for the software for Unitron Truefit and Phonak Target, can someone help me.
Thank you very much and I wish you good hearing.
1 Like
Hello tenka… would you like to shard with me , about sofaware unitron true fit but the version that still uses cube I. thanks
Sure, check your PM.
If you are looking for the most recent version of TrueFit that also supports the obsolete fitting device (iCube) then ask for (TrueFit 5.0). It is the most advanced version that also has the ability to support iCube. And, don’t take any updates to a later version, otherwise you will lose the ability to support iCube.
HI there,
would anyone kindly share a link for truefit software please? appreciate a lot!
Welcome to the forum, sure but don’t forget you’ll need the correct programming device as well for DIY projects.
What models from Unitron are you using.
Hi guys!.. I was looking for version 5 of the true fit software… Is there a link to where I can download it from?